Tractor installation
Brackets
The supplied tractor pillar bracket (A) has a hole spacing of 3.9 in.
(100mm) and 4.7 in. (120 mm). Check tractor instructions manual for
information regarding attachment points.
Three tubes (B) are supplied. One, two or all three may be used. They
can be bent and shortened. A spacer (C) is also supplied to allow
further attachment possibilities. Find the best solution for your trac-
tor or vehicle.
Tube (B) plate is staggered so all boxes will line up if correctly orient-
ed.
Spray box
Best placement is to the right of the driver seat and in combination
with the Controller. It should be secured from movement.
Controller
Mount it in the tractor cabin at a convenient place.
ATTENTION! An extension cable is available as an option if the
Hydraulics control unit is to be placed further away from the
EFC control unit. (Ref. no. 261933)
Printer
If the 12 Volt printer is fitted, the supplied tube can be utilized to fit the printer on the Controller/Terminal brackets.
ATTENTION! The Controller/Terminal should be protected from moisture and should be removed if the tractor
does not have a cabin.
4 - System setup
4.1