Menu 3.3 Boom; Menu 3.3.1 Width; Menu 3.3.2 Number Of Sections; Menu 3.3.3 Nozzles/Section - Hardi HC5500 Instruction Book

Hide thumbs Also See for HC5500:

Table of Contents

Menu 3.3 Boom

Use the navigation keys to enter boom width.

Press # to confirm.

Use the navigation keys to set number of boom sections.

Press # to confirm.

Use navigation keys to set correct number of nozzles per section.

Press # to continue to next boom section.

Press # after the last section.

If end nozzles are fitted, set the value to the equivalent coverage by

the boom nozzles. E.g. End nozzle coverage is 5 feet. This is equal to

[03 Boom nozzles].

ATTENTION! It is important that the volume applied from the end nozzle matches the volume applied under the

boom. This is a comparison of volume per minute per length. (Gallon/min/foot).

When the end nozzle is active, the area covered and volume sprayed is calculated and registered. If "Active boom

size" is displayed, it will show an increase when the end nozzle is activated.

7 - Menu 3 Calibration

7.7

Table of Contents