Menu 1 Daily Settings; Menu 1.1 Volume Rate; How To Change The Volume Rate - Hardi HC5500 Instruction Book

Hide thumbs Also See for HC5500:

Table of Contents

5 - Menu 1 Daily settings

The volume rate can be changed by:

1. Setting the desired rate in the Controller.

2. Manually raising or lowering the pressure via the Spray Box.

3. Pressing ¿ or ª to apply over or under in a preset percent-

age, e.g. 10% (the 3rd line indicates when this is active) or

4. Pressing ¿ or ª to change to one of 3 preset volume rates.

Items 3 or 4 are only possible for broad-acre spraying.

To read the Volume rate:

Shortcut ¥

Press ¥ and hold until menu [1.1 VOLUME RATE] is shown.

To change volume rate:

Move cursor with ¶ or § to the value to be changed.

Use ¿ or ª to change the value.

Press # to confirm.

Press ~ and hold to exit the menu system.

If the volume rate is set up with 3 programmable rates, there are

three possibilities to enter volume rate.

[1.1.1 Rate 1]

(Default)

[1.1.2 Rate 2]

[1.1.3 Rate 3]

Manual dosage

To dose in manual mode, use the pressure switch on the Spray Box.

The manual mode is indicated by the ¬ symbol at the top of the

display.

To go from manual to preset volume rate, press ¢.

ATTENTION! Under 0.3 mph (0.5 km/h), the Controller will not regulate automatically.

5.1

Table of Contents