Speed Transducer For Tractor/Sprayer; Foot Pedal Remote On/Off (Optional); System Start-Up - Hardi HC5500 Instruction Book

4 - System setup

Speed transducer for tractor/sprayer

Note the following if the speed transducer is fitted to the tractor or
vehicle.
The speed transducer is an inductive type. It requires a metallic pro-
trusion (e.g. bolt head) to pass by it to trigger a signal.
Recommended distance between protrusion and transducer is 1/8"
to 3/16" (3 to 5 mm).
A speed/switch harness (A) and extension cable are needed to con-
nect the speed transducer to the Controller/Terminal.

Foot pedal remote ON/OFF (optional)

Note the following if the Foot pedal remote is to be fitted.
Remote ON/OFF switch has to be activated from the extended
menu at installation. The HARDI® Service center does this.
The speed/switch harness (A) is connected to the
Controller/Terminal. Connect the plug from the Foot pedal ON/OFF
to the correct connector on harness (A).
ATTENTION! The main ON/OFF valve switch at Spray Box overrides all remote switches. It must be set to ON for the
optional Remote ON/OFF switch to function.

System start-up

When connecting the 39 pin plug from the sprayer, note the lock
tab (A) clicks in place to secure the plug in the socket.
When disconnecting the plug, the metallic tab must be pushed
back before the plug is pulled out.
After connecting the plugs, the power is turned on at the Spray Box.
Model, software version number, number of sections and size are
displayed briefly. At initial start up, Controller also prompts for input
of time and date. [Set clock to enable register].
Press # to continue.
ATTENTION! At first start-up the clock must be set. See "Menu
2.4 Set clock".
4.2