Menu 3.1 Speed calibration
Menu 3.1.1 Sprayer
The calibration process is the same for each sensor type. In the fol-
lowing example a "speed sensor on sprayer" is used.
Shortcut *
1. Press * until menu [3.1.1 Sprayer] is shown.
It is possible to connect the speed sensor at different locations. They
are calibrated in the following menus:
[3.1.1 Sprayer]
Speed sensor on sprayer
[3.1.2 Tractor]
Speed sensor on tractor
[3.1.3 Radar]
Radar speed sensor
2. Choose with the navigation keys.
3. Press # to confirm. The last confirmed sensor is the active
speed sensor.
Shortcut *
4. Press * until menu [3.1.X "Speed abc"] is shown.
5. Choose speed transducer. (Sprayer, Tractor or Radar) [3.1.1
Sprayer]
6. Press # to confirm.
7. Press # to read PPU value.
The speed transducer can be calibrated theoretically or practically.
The practical method is recommended.
Menu 3.1.1.1 Constant
The theoretical speed constant, pulses per unit (PPU), is the distance
in feet on the circumference of the wheel between holes (A) (or pro-
trusions / magnets (B)) that the speed sensor records.
7 - Menu 3 Calibration
7.1