Menu 1 Daily Settings; Menu 1.1 Volume Rate; Menu 2 Setup - Hardi 5500 Instruction Book

Menu 1.1 Volume rate

The volume rate can be changed by:
1. Setting the desired rate in the Controller.
2. Manually raising or lowering the pressure via the Spray Box.
3. Pressing or
e.g. 10% (the 3rd line indicates when this is active)
or
4. Pressing or
Items 3 or 4 are only possible for broad-acre spraying.
To read the Volume rate:
Shortcut .
Press and hold until menu [1.1 VOLUME RATE] is shown.
1.1
VOLUME RATE
To change volume rate:
Move cursor with
Use or to change the value.
Press to confirm.
Press and hold to exit the menu system.
If the volume rate is set up with 3 programmable rates, there are three
possibilities to enter volume rate.
[1.1.1 Rate 1] (Default)
[1.1.2 Rate 2]
[1.1.3 Rate 3]
NOTE: Normally, under 0.5 km/h, the Controller will not regulate automatically.
Manual dosage Manual dosage
Manual dosage Manual dosage Manual dosage
To dose in manual mode, use the pressure switch on the Spray Box. The
manual mode is indicated by the
To go from manual to preset volume rate, press
HARDI CONTROLLER 5500
to apply over or under in a preset percentage,
to change to one of 3 preset volume rates.
or to the value to be changed.
symbol at the top of the display.
XXXX L/ha
.
13