Table of Contents
Advertisement
Tractor installation
Installation of control unit brackets
Find a suitable place in the tractor's cabin to secure the control units
from movement. Best recommended placement is to the right of the
driver seat.
The supplied tractor pillar bracket (A) has a hole spacing of 3.9 in. (100
mm) and 4.7 in. (120 mm) and will fit most tractors. Threaded mounting
holes may be hidden behind front corner cover.
ATTENTION! Check tractor instructions manual for information
regarding attachment points.
Three tubes (B) are supplied. One, two or all 3 may be used. They can be
bent and shortened. A spacer (C) is also supplied to allow further
attachment possibilities. Find the best solution for your tractor or
vehicle.
Tube (B) plate is staggered so all boxes will line up if correctly oriented.
The recommended setup is to place the spacer (C) between the two
tubes (B) used for the controllers and the 3rd tube (B) as shown in the
picture, so it can be mounted in the bracket (A).
Printer
If the 12 Volt printer is fitted, the supplied tube can be utilized to fit the printer on the Controller brackets.
ATTENTION! The Controller should be protected from moisture and should be removed when not in use, if the tractor
does not have a cabin.
4 - System setup
C
B
A
100/120mm
4.1
Hide quick links:
Advertisement
Table of Contents
