Keystroke Menu Tree; Extended Menu - Hardi HC5500 Instruction Book

Keystroke menu tree

The first steps to choose a menu are shown below.
Press # to proceed into the menu. See the relevant section in the book.
Press ~ and hold to exit the menu system.
Main menu

Extended menu

This menu has been set up by your HARDI® Service center. It contains parameters that are typically set only once, normal-
ly before the Controller is used.
ATTENTION! Unless instructed, do not tamper with the settings and values in these menus. Failure to do so may
void warranty.
5 Logbook
4 Toolbox
3 Calibration
2 Setup
1 Daily settings
3 - Description
5.1 Print
5.2 Data dump
4.1 Measure
4.2 Service intervals
4.3 Stop watch
4.4 Alarm clock
4.5 Test
4.6 Speed simulation
4.7 Emergency track
3.1 Speed
3.2 Flow
3.3 Boom
3.4 Regulation constant
3.5 Tank gauge (unavailable option)
3.6 Track
3.7 LookAhead
2.1 Display readout
2.2 AUTO functions
2.3 GPS/Remote
2.4 Set clock
2.5 Alarms
2.6 Register names
1.1 Volume rate
1.2 Tank contents
1.3 Select register
3.7