System Setup; Tractor Installation; Control Units; Installation Of Control Unit Brackets - Hardi HC5500 Instruction Book

Hide thumbs Also See for HC5500:

Table of Contents

Find a suitable place in the tractor's cabin to secure the control units

from movement. Best recommended placement is to the right of the

driver seat. The supplied bracket will fit most tractors. Threaded

mounting holes may be hidden behind front corner cover.

The supplied tractor pillar bracket (A) has a hole spacing of 100 and 120

mm. Check tractor instructions manual for information regarding

attachment points.

Three tubes (B) are supplied. One, two or all 3 may be used. They can be

bent and shortened. A spacer (C) is also supplied to allow further

attachment possibilities. Find the best solution for your tractor or

vehicle.

Tube (B) plate is staggered so if correctly orientated, all boxes will line up.

The recommended setup is to place the spacer (C) between the two

tubes (B) used for the controllers and the 3rd tube (B) which is to be

mounted in the bracket (A), as shown on the picture.

ATTENTION! An extension cable is available as an option if the HC

5500 control unit is to be placed further away from the EFC

control unit. (Ref. no. 261933)

4 - System setup

100 -120mm

Table of Contents

Show Quick Links

Table of Contents