Menu 3.6 Safetrack; Safetrack; Menu 3.6.1 Track Width; Menu 3.6.2 Tractor Drawbar - Hardi HC5500 Instruction Book

Hide thumbs Also See for HC5500:

Table of Contents

Menu 3.6 SafeTrack

The SafeTrack is operated at the hydraulic control box. Track selec-

tion switch (12) has 3 positions:

1. When pressed downwards, the sprayer will align to be in position

for folding the boom.

2. When the switch is the middle position, the system is in auto and

the sprayer track will follow the track from the tractor.

3. When the switch is in the upper position, the system is in manual,

and the switch (11) can be used for steering the sprayer right and

left.

ATTENTION! When driving in hilly terrain, the manual steer

button (11) can be used to optimize the tracking. Before

reaching the headland, switch the track selection switch (12)

to manual and back to auto to neutralize the offset.

Here the distance from right side tire center to left side tire center

can be entered.

Factory setting: 71 in

Here the length of the tractor drawbar is entered. The measurement

is from the center of the tractor rear axle to the center of the draw-

bar pin.

Factory setting: 31 in

This is the non regulation zone when the sprayer is straight behind

the tractor, if the sprayer is oscillating in the hydraulics when driving

straight, this value can be increased.

Factory setting: 2 in

7 - Menu 3 Calibration

7.9

Table of Contents