Menu 4.3 Stop Watch; Menu 4.3.2 Activate Stop Watch; Menu 4.4 Alarm Clock; How To Use Alarm - Hardi HC5500 Instruction Book

Hide thumbs Also See for HC5500:

Table of Contents

8 - Menu 4 Toolbox

Menu 4.3 Stop watch

The clock can be used as a timer.

Press # to start and stop.

Use | to clear the value.

The clock can be set to give an alarm when the time is reached.

Press ¿ or ª. Use navigation keys to set alarm.

All readouts for the transducers are in accumulated counts, i.e. one

signal gives one count, except for the optional (analog) transducer

that is read in milli-ampere.

Go to menu [4.5 Test]. Choose the item to be tested and open the

menu. Activate sensor and see if the signal is detected.

[4.5.1 Flow]. Enter this menu to test the flow sensor.

[4.5.2 Speed].

[4.5.3 Optional sensor].

[4.5.4 Active switches].

Speed may be simulated for certain purposes. A two figure value may be entered. The state remains valid until the

Controller is re-started or the value is set to "0".

8.2

Table of Contents