Menu 3 Calibration; Menu 3.1 Speed Calibration - Hardi ISOBUS VT Operator's Manual

Menu 3 Calibration

Menu 3.1 Speed calibration

The calibration process is the same for each sensor type. In the following
example a "speed sensor on sprayer" (Menu 3.1.1 Sprayer) is used.
The menu can be reached by navigating via the menu structure.
Navigating the menu
1. From menu [3 Calibration] the menu [3.1 Speed calibration] should
be selected.
2. Select one of the following menus corresponding to desired speed
sensor:
[3.1.1 Sprayer] Speed sensor on sprayer
[3.1.2 Tractor] Speed sensor on tractor (use for GPS speed)
[3.1.3 Radar] Radar speed sensor
3. The last confirmed sensor is the active speed sensor.
4. Choose submenu.
It is possible to calibrate the speed sensor in different ways. You may enter a theoretical speed constant or perform a
practical calibration.
Select calibration method in the two submenus
Menu Function
3.1.1.1 Speed constant
3.1.1.2 Speed practical
Select one of the calibration methods using the navigation keys, then
press Enter to accept.
The procedure for each menu is described in the following sections.
ATTENTION! The practical method is recommended.
ATTENTION! If the speed cannot be calibrated, then deactivate the track function. Contact your HARDI® service center
to do this.
7 - Menu 3 Calibration
7.1