Extended Menu - Hardi ISOBUS VT Operator's Manual

3 - Description
ATTENTION! The procedure for the following two steps can vary between ISOBUS terminals. Procedure for HC 9500
terminal is shown here.
4. Select the value field to enter a value.
5. Enter the new tank contents value on the
numeric key pad and select check mark to
confirm.

Extended menu

This menu has been set up by your HARDI® Service center. It contains parameters that are typically set only once, normally
before the Controller is used.
• For ISOBUS terminals the extended menu is accessible from menu 2.8 and requires a pin code to enter.
ATTENTION! Unless instructed, do not tamper with the settings and values in these menus. Doing so may void
warranty.
3.10