Table of Contents
Advertisement
5. Select register for the present spray job (if desired).
6. For SafeTrack, the sensitivity of the tractor hydraulic must be
calibrated. Follow the instructions written in the bottom of the
display.
÷
NOTE! The calibration can only be done with the boom unfolded!
Volume rate
÷
NOTE! When used on an HC 9500 ISOBUS terminal, the volume rate must be set in the HC 9500 software when its
graphical field functions are used (not running Virtual Terminal only). In such case, please refer to the HC 9500
instruction book for set up of volume rate.
If running Virtual Terminal only on a HC 9500 the following procedure applies.
The volume rate can be changed by
• Setting the desired rate in the Controller.
• Manually raising or lowering the pressure via the SetBox.
• Pressing {%-up} or {%-down} to apply over or under in a preset percentage, e.g. 10% (the %-icon in the display indicates
when this is active).
To read the volume rate
Go to menu [1.1 VOLUME RATE] to read volume rate
To change volume rate
1. Go to menu [1.1 VOLUME RATE].
2. Change the value. Alternatively clear value by pressing Clear and key in value on the numeric keys.
3. Press Enter to confirm.
Manual dosage
To dose in manual mode, use the pressure buttons on the SetBox. The manual mode is indicated by the
top of the display.
To go from manual to preset volume rate, press AUTO.
ATTENTION! Under 0.3 mph (0.5 km/h), the Controller will not regulate automatically.
4 - System setup
symbol at the
4.5
Hide quick links:
Advertisement
Table of Contents
