Speed Transducer For Sprayer; How To Set Clock - Hardi ISOBUS VT Operator's Manual

4 - System setup

Speed transducer for sprayer

The speed transducer is located at the inside of the sprayer's right wheel.
It is an inductive type that requires a metallic protrusion to pass by it to
trigger a signal. A speed ring is used to trigger the transducer. It should
be adjusted so the transducer is placed in the center of the holes in the
speed ring (vertical direction). Recommended distance between
protrusion and transducer (A) is 1/8" to 1/4" (3 to 6 mm). Check
throughout the entire circumference. Correct adjustment is indicated by
a constant blinking from the transducer when the wheel rotates.

How to set clock

If time or date is out of adjustment, it can be corrected as follows.
ATTENTION! This must be done at very first start-up, when prompted. If no prompt, the HARDI® dealer may have done
this.
1. Press {Enter} on ISOBUS Terminal.
2. Press {down} arrow to menu [2 Setup]. Press {Enter}.
3. Press {down} arrow to menu [2.4 Set clock]. Press {Enter}.
4. Press {Enter} to enter first submenu, menu [2.4.1 Time format (12 or 24 hour)].
5. By using {up} or {down} arrows you can choose between:
Menu [2.4.1.1 12 hour format].
Menu [2.4.1.2 24 hour format].
6. Press {Enter} to select format and return to previous menu by pressing {ESC}.
7. Press {down} arrow to menu [2.4.2 Set time].
8. Press {Enter} and select minutes or hours, then enter value with numeric keys.
9. Press the check mark to confirm.
10. Press {down} arrow to menu [2.4.3 Set date and month].
11. Press {Enter} and select day or month, then enter value with numeric keys.
12. Press the check mark to confirm.
13. Press {down} arrow to menu [2.4.4 Set year].
14. Press {Enter} and select year, then enter value with numeric keys.
15. Press the check mark to confirm.
16. Press {ESC} to exit menu.
4.2