Register Readout And Selection; Tank Contents - Hardi ISOBUS VT Operator's Manual

4 - System setup

Register readout and selection

Registers are identified with a number. The data is saved when the
system is switched off.
• Register 1 to 98 can be used for individual areas.
• Register 99 is a tally of register trips 1 to 98.
To read the totals of all registers:
1. Go to menu [1.3 Select register].
2. Go to register 99.
3. Press Enter to enter the register and read main data.
4. Press Enter again to see spray data.
5. Press Escape to exit the menu.
To read the data in the active register:
1. Go to menu [1.3 Select register].
2. Press Enter to enter register and read main data.
3. Press Enter again to see spray data.
4. Press Escape to exit the menu.
To change the register:
1. Go to menu [1.3 Select register].
2. Press up or down arrow to change the register.
3. Press Enter. If necessary, the register can be reset - see below.
4. Press Escape to exit the menu.
To reset register:
Press Escape and hold for 5 seconds to reset register. Status diode will blink once, and then blink again to indicate that
register has been reset.
Reset of a register can be stopped if the Escape key is released before the status diode is blinks again.
ATTENTION! The active register number is always visible in the right upper corner of the display.

Tank contents

To change the displayed tank contents:
1. Go to menu [1.2 Tank contents].
2. Set the value.
3. Press Enter to confirm.
4. The maximum size of the tank is displayed.
ATTENTION! If the sprayer is fitted with Tank gauge, contents
readout is automatic.
4.6