Table of Contents
Advertisement
Menu 4 Toolbox
Menu 4.1 Measure
This is a simple electronic trip meter. You can measure distance. If the implement width is entered in menu [4.1.3 Working
width], area can also be measured in menu [4.1.2 Area].
1. Press Clear to clear the value.
Following submenus are possible:
[4.1.1 Measure Distance]
Measures a distance being travelled.
[4.1.2 Measure Area]
Measures the area the boom covers at a travelled distance.
[4.1.3 Setup working width]
Menu for entering the boom working width to be measured.
[4.1.4 Stop-watch]
Measures the time being used.
[4.1.5 Alarm clock]
Can give an alarm at a preset time.
Menu 4.2 Service intervals
Service intervals and a nozzle check are programmed into the Controller. This makes it easier for the operator to remember
the service intervals.
From the factory, the Controller is set up with three service and a nozzle check reminder.
Menu & interval
[4.2.1 Check filters]
[4.2.2 Grease boom]
[4.2.3 Grease track and center]
[4.2.4 Miscellaneous service]
[4.2.5 Check nozzles]
Entering the above menu's will display the hours remaining until next service. The importer or dealer may have added a
"Miscellaneous service" interval. If no interval is set, [Miscellaneous service not defined] is shown.
Press Enter to register service or control, if displayed when switched on. The warning
interval is reset.
Menu 4.3 Service interval reset
To reset service interval, go to relevant interval menu listed:
Menu & interval
[4.2.1 Check filters reset]
[4.2.2 Grease boom reset]
[4.2.3 Grease track and center]
[4.2.4 Miscellaneous service]
[4.2.5 Check nozzles]
1. Press Clear to reset hour meter.
2. Press Enter to confirm.
Menu 4.4 Reserved
Reserved function - This menu is not used
Hours
Action
10
See sprayer instruction book, Maintenance.
50
See sprayer instruction book, Maintenance.
250
See sprayer instruction book, Maintenance.
0
Not defined from factory.
10
Check flow rate. Change nozzles if more than 10% of rated flow.
Hours
Action
10
See sprayer instruction book, Maintenance.
50
See sprayer instruction book, Maintenance.
250
See sprayer instruction book, Maintenance.
-
Not defined from factory.
10
Check flow rate. Change nozzles if more than 10% of rated flow.
8 - Menu 4 Toolbox
will remain present until the service
8.1
Hide quick links:
Advertisement
Table of Contents
