Safetrack (Trailed Sprayers Only); Hardi® Autosectioncontrol (Optional) - Hardi ISOBUS VT Operator's Manual

3 - Description
Controller reaction
Spraying (boom is open)
Boom is open and sprays.
Both flow measurement and pressure
measurement are good, and the actual
nozzle size is calculated.
The actual nozzle size is used to adjust to
correct liter/ha.

SafeTrack (Trailed sprayers only)

SafeTrack is a steering mechanisms for the trailed HARDI® sprayers. When using a track system, sprayer stability is a common
concern. Many factors influence the sprayer and conditions where the sprayer might tip over have to be dealt with.
The factors that the driver can influence with are
• Driving behavior
• Field conditions
• Tire width
• Tire pressure
Read sprayer's instruction book for further information. If unsafe driving occurs, an alarm will be triggered and the sprayer
will align. Be aware that the alarm cannot be turned off as long as unsafe driving still occurs!
ATTENTION! If necessary, the level of security can be adjusted - please contact your local HARDI® dealer.
€
DANGER! The system has been calibrated during driving on flat fields. Special attention should be made when driving
in hilly conditions.
€
DANGER! When driving on fields with deep tracks, then the speed must be decreased.
HARDI® AutoSectionControl (optional)
HARDI® AutoSectionControl will:
• manage the sections when driving over sprayed area, like into a headland or wedge or around obstacles like trees, etc.
• automatically record the area sprayed, when spraying.
In a typical situation where the headland is sprayed first, HARDI® AutoSectionControl will now automatically close the
sections if the operator passes over a sprayed area.
ATTENTION! Variable Rate Application needs to be enabled for AutoSectionControl to work - refer to "Menu 2.3
Variable Rate Application (VRA) / Remote / HARDI® AutoSectionControl" on page 6.3.
ATTENTION! For more information about AutoSectionControl, see the AutoSectionControl instruction book. On
ISOBUS terminals AutoSectionControl can be an integrated part - if so, refer to the ISOBUS terminal instruction book.
3.14
Flow and pressure are
good
Both flow measurement and
pressure measurement are
good.
Software disables max.
pressure limit.
Controller reaction
Spraying (boom is open)
Boom is open and sprays.
Software uses last saved nozzle size and pressure sensor to
adjust to correct liter/ha.
Max. pressure limit is enabled to avoid overpressure in case
operator had changed to smaller nozzles.