Engine
• Remove the rocking lever shafts.
• Remove the rocking levers and collect the three
washers.
See also
Removing the head cover
Removing the valves
•
Remove the head.
•
Place the special tool on the upper cap
and at the centre of the head of the
valve to be removed.
Specific tooling
10.90.72.00 Tool for valve removal and refitting
•
Tighten the tool screw until fitted, and
then hit the tool head (where the upper
retainer works) with a mallet so that the
two cotters (1) get detached from the
upper retainer (2).
•
Once the two cotters (1) are detached,
screw these cotters until they can be
slid off the valve seats; unscrew the
tool and remove it from the head.
ENG - 38
Norge 1200