MOTO GUZZI Norge 1200 Service Manual page 98

Engine
•
Remove the gear of the fifth gear.
•
Remove the circlip, the shoulder wash-
er and remove the gear of the first gear,
collect the ball bearing cage.
•
Remove the bearing if necessary.
See also
Disassembling the gearbox
Disassembling the clutch shaft
•
Remove the gearbox from the engine
block.
•
Remove the gearbox.
•
Insert the clutch shaft in the special tool
for removal.
Specific tooling
000019663300 Tool for clutch shaft removal
•
Compress the Belleville springs (10) until releasing the two half-rings (12).
•
Remove the Belleville springs (10).
•
Remove the washer (11).
•
Remove the shaped washers (8).
•
Remove the sleeve (7).
•
Remove the circlip (6).
•
Remove the transmission gear (5).
•
Collect the clutch shaft (4).
CAUTION
ENG - 16
Norge 1200