MOTO GUZZI Norge 1200 Service Manual page 162

Power supply
13. Side stand
14. Fall sensor
Cylinders synchronisation
•
With engine off, connect the Axone
2000 tool to the diagnosis connector
and to the vehicle battery.
•
Turn on the scanner.
•
Screw the joints connecting the vacuometer pipes on the inlet pipe holes.
•
Connect the vacuometer pipes to the relative joints.
•
Set the key to ON.
•
Make sure there are no errors in the control unit; otherwise, solve them and repeat the
procedure.
•
Make sure the left throttle is fully in.
DO NOT TOUCH THE THROTTLE ABUTMENT
SCREW OR THE THROTTLE BODY MUST BE
REPLACED. CHECK THAT THE THROTTLE
RETURN CABLE IS NOT TAUT.
•
The Axone should display the adjustable parameters screen.
•
Autodetect the throttle position.
P SUPP - 4
Norge 1200