Device Status - MOTO GUZZI Norge 1200 Service Manual

Power supply
Specification
Stepper regulator
Virtual throttle angle from Stepper
Device status screen page

DEVICE STATUS

This screen page shows the status (ON/OFF only)
of the vehicle devices or the operation condition of
some vehicle systems (for example, lambda probe
functioning status)
Specification
Engine status
Throttle position
Stand
IGNITION
RUN / STOP switch
Clutch
Gear engaged
Fall sensor
Lambda
Synchronisation
P SUPP - 8
Steps set by the control unit for the Stepper motor.
At idle, steps so that the engine keeps the target
engine revs set by the control unit
Difference between current steps of motor at idle
and those at the reference position
With engine not at idle speed, this value indicates
the throttle degrees corresponding to the Stepper
D
EVICE STATUS
ON/run/power-latch/stopped
operation conditions
Released / pressed
indicates if the throttle potentiometer is open or
Retracted / expanded
indicates the position of the side stand (only with
Enabled / disabled
indicates if the control unit consents engine start-
indicates the position of the safety switch
indicates the clutch sensor status
indicates the gear sensor status
indicates the vehicle fall sensor status
Open loop / Closed loop
Indicates if the control unit is using (CLOSED) the
lambda probe signal to keep the stoichiometric
combustion. At idle CLOSED only if: Air T over 20°
C (68°F) and engine T over 30°C (86°F) and en-
gine on for at least 2-3 minutes
Synchronised / Not synchronised
Norge 1200
Desc./Quantity
0°
motor air flow
Desc./Quantity
closed
gear engaged)
up
Run / stop
No / Yes
No / Yes
Normal / Tip over