MOTO GUZZI Norge 1200 Service Manual page 196

Chassis
Checking
•
Check that the universal joint is not damaged, the gear teeth inserting in the sleeve grooves
and the grooves on the joint are not deformed or damaged; otherwise, replace the joint.
•
Check that the rubber bellows are not cut or pierced; otherwise, replace it.
•
Check that the fork pin threads and the fork fixing nuts are not damaged, deformed or flat-
tened; otherwise, replace them.
•
Check that the sleeve grooves are not damaged, deformed or deteriorated; otherwise, re-
place the sleeve.
•
Check that the sleeve outer toothing and grooves are not damaged.
Installing
•
Spread a thin layer of lubricating
grease all along the fork pin.
•
Fit the ring nut in the fork pin and screw
it manually.
•
Working from both sides, grease the
cardan shaft cables with the recom-
mended product from the recommen-
ded products table.
•
Block the fork, insert the universal joint,
align the holes and, at the same time,
helped by a second operator, insert the
pin completely.
•
Tighten the fork pin.
CHAS - 4
Norge 1200