MOTO GUZZI Norge 1200 Service Manual page 250

Bodywork
•
Fit the spacer (19) on the plate (5).
•
Insert the screw (21) and the washer
(20) inside the plate (5).
•
Fit the spacer (17) on the screw (21).
•
Position the movable support (11).
•
Fit the washer (7).
•
Tighten the nut (16) to the specified
torque.
Locking torques (N*m)
M6 Electric windshield supports retainer 12
Nm
•
Position the plate (5) on the front
frame.
•
Tighten the four screws (3c).
•
Tighten but not lock the two screws
(3b).
•
Connect the electric windshield motor
connector to the main wiring.
•
Tighten but not lock the four screws
(3d).
•
Tighten but not lock the four screws
(3a) with washers (7) on the sliding
blocks (4).
To carry out the tightening, proceed as follows and remember to make sure that after being lifted, the
plate (5) always comes down freely (without being forced):
BODYW - 12
Norge 1200