MOTO GUZZI Norge 1200 Service Manual page 133

Norge 1200
•
Turn the oil pump shaft and introduce
the gear pulling woodruff key.
•
Introduce the chain tensioner.
•
Remove the flywheel locking tool.
•
Check the crankshaft rotation.
•
Fit the rocking levers.
Specific tooling
12.91.18.01 Tool to lock flywheel and start-up crown gear
Timing
To check distribution timing, follow these instruc-
tions:
•
Obtain a clearance between rocking
levers and valves equal to 1.5 mm
(0.059 in);
•
Place the hub for graduated dial and
the relative graduated dial on the
crankshaft slot, inserting the spacer
and fixing it to the shaft with the nut.
Specific tooling
981006 Graduated dial hub
19.92.96.00 Graduated dial to control ignition
timing
Engine
ENG - 51