Removing The Valves; Checking The Valve Guides - MOTO GUZZI Griso1200 8V Service Station Manual

GRISO 8V - 1200
•
Remove the two rocking levers from
the cam cap.
See also
Removing the cylinder head

Removing the valves

•
Remove the head.
•
Place the special tool on the upper cap
and at the centre of the head of the
valve to be removed.
Specific tooling
10.90.72.00 Tool for valve removal and refitting
AP9100838 Tool for valve pressure plate
•
Tighten the tool screw until fitted, and
then hit the tool head (where the upper
cap works) with a mallet so that the two
cotters (1) get detached from the upper
cap (2).
•
Once the two cotters (1) are detached,
screw these cotters until they can be
slid off the valve seats; unscrew the
tool and remove it from the head.
•
Slide off the upper cap (2).
•
Remove the spring (3).
•
Remove the lower cap (5) and the
valve guide oil seal (4), if necessary.
•
Remove the valve (6) from inside the
head.

Checking the valve guides

Use a punch to extract the valve guides from the heads.
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
Engine
ENG - 133