Accessing Programming Mode - modbar av Series Manual

Programming Mode
GH 105.0°C G1
█
OT 95.5°C 0.0
█
Display
1
G1 MODBAR G2
█ █
While the espresso machine is on, press and hold the button T3
163Puls 0Puls
following display appears.
This is the "Barista" programming level. To program the brewing amount for each button, to set the coffee
2
Group Dose
boilers, the pre-infusion, and to enable/disable the resistance.
Settings
To exit the programming mode, scroll to the exit menu, using the buttons T1
3
Exit
Menu
button to confirm the exit, or press at the same time the buttons T2 and T3.
Description
• To change the values of any parameter
the operator must first enter into the
programming mode.
• There are two levels within the
programming mode that allow the
programming of specific parameters.
• The two programming levels are as
follows:
Operating Procedure
Barista" Programming Level

Accessing Programming Mode

• Barista Programming - The parameters
contained within this level are ones
the operator can change to affect the
quality of the espresso.
No password is required for access.
. After approximately 5 seconds the
or T2 . Press the T3
41