SEW-Eurodrive Movigear Performance MGF**-DFC-C Series Operating Instructions Manual page 169

Subfault: 10.7
Description: Calculation result of multiplication/division command too large
Response: Application stop + output stage inhibit
Calculation result of multiplication/division com-
mand exceeds 32 bits.
Failed to write calculation result of multiplication/
division command into result variable.
Subfault: 10.8
Description: Illegal connection
Response: Application stop + output stage inhibit
Index used in connect not allowed.
Subfault: 10.9
Description: CRC code
Response: Application stop + output stage inhibit
Wrong CRC checksum of code.
Subfault: 10.10
Description: Setpoint cycle time not supported
Response: Application stop + output stage inhibit
Non-supported setpoint cycle time parameterized. Set the setpoint cycle time to the default value 1
Subfault: 10.11
Description: No application program loaded
Response: Output stage inhibit
No Data Flexibility application program loaded.
Subfault: 10.99
Description: Unknown error
Response: Application stop + output stage inhibit
Unknown Data Flexibility error.
Cause
Cause
Cause
Cause
Cause
Cause
Measure
Check the program.
Check the program.
Measure
Check the program. The index used either does
not exist or is not permitted for access via pro-
cess data, see parameter list.
Measure
Load the program again. The program memory is
corrupt. An unauthorized write access has been
carried out on the program memory.
Measure
ms.
Measure
Load the program or disable Data Flexibility.
Measure
Contact SEW-EURODRIVE Service.
Operating Instructions – MOVIGEAR
Service
8
Fault table standard
169
®
performance