SEW-Eurodrive Movigear Performance MGF**-DFC-C Series Operating Instructions Manual page 144

Operation
7
DynaStop® in conjunction with STO
7.5.1 Using the DynaStop
Index Parameter/setting
8563.1 Stop default DT1
0 = brake not ap-
plied/drive energized
Stop default DT1
1 = Brake applied/
drive not energized
8501.3 Apply brake/
DynaStop
state
0 = NO
Apply brake/
DynaStop
state
1 = Yes
Required settings
Recommended setting
144
Operating Instructions – MOVIGEAR
®
function in connection with the STO function
To use the DynaStop
SEW‑EURODRIVE recommends control according to SS1(c).
To do so, the parameter setting "Stop default DT1" = 1 (Brake applied/drive not ener-
gized) is required (default setting).
The following table shows the behavior of the DynaStop
parameter setting:
The drive decelerates along the set ramp. When the drive reaches
speed "0", DynaStop
The drive decelerates along the set ramp. When the drive reaches
speed "0", DynaStop
The DynaStop
®
in STO
®
DynaStop
®
in STO
®
performance
®
function in connection
Meaning
®
is not activated.
®
is not activated safety-relatedly.
®
status remains unchanged when STO is triggered.
is activated (not safety-related) when STO is triggered.
with the STO function,
®
function depending on the