Designated Use; Functional Safety Technology - SEW-Eurodrive Movigear Performance MGF**-DFC-C Series Operating Instructions Manual

Safety notes
2

Designated use

Specialist for elec-
trotechnical work
Additional qualifi-
cation
Instructed persons
2.4 Designated use
2.4.1 Lifting applications
2.5

Functional safety technology

10
Operating Instructions – MOVIGEAR
Any electrotechnical work may only be performed by electrically skilled persons with a
suitable education. Electrically skilled persons in the context of this documentation are
persons familiar with electrical installation, startup, troubleshooting, and maintenance
of the product who possess the following qualifications:
• Qualification in the electrotechnical area in accordance with the national regula-
tions
• Familiarity with this documentation
In addition to that, these persons must be familiar with the valid safety regulations and
laws, as well as with the requirements of the standards, directives, and laws specified
in this documentation.
The persons must have the express authorization of the company to operate, pro-
gram, parameterize, label, and ground units, systems, and circuits in accordance with
the standards of safety technology.
All work in the areas of transportation, storage, operation and waste disposal must be
carried out by persons who are trained appropriately. The purpose of the instruction is
that the persons are capable of performing the required tasks and work steps in a safe
and correct manner.
The product is intended for installation in electrical plants or machines.
In case of installation in electrical systems or machines, startup of the product is pro-
hibited until it is determined that the machine meets the requirements stipulated in the
local laws and directives. For Europe, Machinery Directive 2006/42/EC as well as the
EMC Directive 2014/30/EU apply. Observe EN 60204-1 (Safety of machinery - elec-
trical equipment of machines). The product meets the requirements stipulated in the
Low Voltage Directive 2014/35/EU.
The standards given in the declaration of conformity apply to the product.
Technical data and information on the connection conditions are provided on the
nameplate and in the chapter "Technical data" in the documentation. Always comply
with the data and conditions.
Unintended or improper use of the product may result in severe injury to persons and
damage to property.
Do not use the product as a climbing aid.
The product may not be used for lifting applications.
For applications with inclining tracks, you must only use the product after a risk as-
sessment is performed by the user. For further information, consult the information in
the documentation.
The product must not perform any safety functions without a higher-level safety sys-
tem, unless explicitly allowed by the documentation.
®
performance