Technical Data - Siemens SINAMICS S120 Manual

DC link components
5.1 Blocksize
Frame size
FSE
FSF
FSF
For 690 V converters:
FSD
FSE
FSF
Always use the screw together with nut and washer.
1)
This braking resistor consists of components JJY:023422620001 and JJY:023434020001, which
2)
must be connected in parallel on the plant/system side.
This braking resistor consists of 2 components JJY:023434020001, which must be connected in
3)
parallel on the plant/system side.
This braking resistor consists of 2 components JJY:023434020002, which must be connected in
4)
parallel on the plant/system side.
Note
PE connection
The PE connection for the braking resistor is established via the shield connection for frame
sizes FSA to FSC.
For installation according to EN 60204-1 and EN 61800-5-1, the PE connection on the
housing must be used. The PE conductor in the pigtail is, in this case, not to be used, but
can be suitably tied off or cut off.
For frame sizes FSD to FSF, the PE connection of the braking resistor is connected at the
sheet steel enclosure above terminals R1 and R2. Optionally, additional shield connecting
plates can be ordered from Siemens.
5.1.1.6

Technical data

Line voltage 1/3 AC 200 V to 240 V ±10 %
Note
Additional combinations are possible through our "Siemens Product Partners for Drive
Options
zubehoer/Seiten/sinamics-zubehoer.aspx)".
Note
Braking resistors FSD ... FSF
Only use braking resistors that are UL approved, and have successfully passed the
"Abnormal Operation Test" according to UL 508.
162
Article number
JJY:023434020001
JJY:023454020001
JJY:023464020001
JJY:023424020002
JJY:023434020002
JJY:023464020002
(https://w3.siemens.com/mcms/mc-drives/de/niederspannungsumrichter/sinamics-
Fastening
4 x M5 screws
1)
2 x 4 x M5 screws
2)
2 x 4 x M5 screws
3)
4 x M5 screws
1)
4 x M5 screws
1)
2 x 4 x M5 screws
4)
Manual, (GH6), 07/2016, 6SL3097-4AL00-0BP5
Tightening torque
6 Nm
6 Nm
1)
6 Nm
1)
6 Nm
6 Nm
6 Nm
1)
AC Drive