Characteristics - Siemens SINAMICS S120 Manual

Power Modules
4.3 Power Modules Chassis
Line voltage 3-ph. 380 V to 480 V AC ±10% (-15% < 1 min)
Article number
Max. ambient temperature
without derating
with derating
Degree of protection
Width
Height
Depth
Weight
Rated power of a typical standard induction motor at 400 V 3 AC
1)
Current consumption of Power Module only. If a Control Unit is supplied with 24 V DC from the Power Module, its
2)
current consumption must be added.
Max. motor cable length 100 m (shielded) in conjunction with a line filter to comply with the EMC limit values of EN
3)
61800-3 Category C2.
Depth = 421 mm including front cover when a Control Unit is installed
4)
4.3.6.1

Characteristics

Note
Derating characteristics
You will find the derating characteristics in Chapter Derating (Page 40).
Overload capability
The Power Modules are equipped with an overload reserve, e.g. to handle breakaway
torques.
In drives with overload requirements, the appropriate base load current must, therefore, be
used as a basis for the required load.
The overload data is valid under the precondition that the Power Module is operated with its
base load current before and after the overload occurs (a load duration of 300 s is used as a
basis here).
154
6SL3310– 1TE32-1AA3
°C 40
°C 55
IP 20 or IPXXB
mm 326
mm 1400
mm 356
4)
kg 104
1TE32-6AA3 1TE33–1AA3 1TE33-8AA3
40 40
55 55
326 326
1400 1533
356 545
4)
104 162
Manual, (GH6), 07/2016, 6SL3097-4AL00-0BP5
1TE35-0AA3
40 40
55 55
326 326
1533 1533
545 545
162 162
AC Drive