Emerson Rosemount 3051 Manual page 104

Rosemount Model 3051 Transmitter with F
Table C-5. Resource Block Parameters (continued)
Parameter
self_test
distributor
REM_SEAL_FILL
REM_SEAL_ISO_MAT
REM_SEAL_NUM
REM_SEAL_TYPE
RESTART
RS_STATE
save_config_blocks
save_config_now
C-10
OUNDATION
Index
Number Description
59 Instructs resource block to perform self-test. Tests are device specific.
42 Reserved for use as distributor ID. No Foundation enumerations defined at this time.
73 Type of fill fluid used in the remote seals.
2 = Silicone
3 = Syltherm 800
4 = Inert (Halocarbon)
5 = Glycerin and Water
6 = Propylene Glycol and Water
7 = Neobee M–20
251 = None
252 = "Unknown"
253 = "Special"
70 Type of material of the remote seal isolators. See remote seal number codes.
2 = 316L Stainless Steel
3 = Hastelloy C–276
5 = Tantalum
9 = Co–Cr–Ni
251 = None
252 = "Unknown"
253 = "Special"
71 Number of remote seals.
1 = One seal
2 = Two seals
251 = None
252 = "Unknown"
253 = "Special"
66 Type of remote seals.
0 = Undefined
1 = Reserved
2 = CTW
3 = EFW (Expanded Flange Seal)
4 = PFW (Pancake)
5 = RFW (Flanged Remote)
6 = RTW (Threaded Remote)
7 = SCW
8 = SSW
9 = High Temperature
10 = FFW (Flanged Flush Surface)
11 = UCW
12 = TSW
251 = None
252 = "Unknown"
253 = "Special"
16 Allows a manual restart to be initiated. Several degrees of restart are possible. They are
the following:
1 Run – nominal state when not restarting
2 Restart resource – not used
3 Restart with defaults – set parameters to default values. See
START_WITH_DEFAULTS below for which parameters are set.
4 Restart processor – does a warm start of CPU.
07 State of the function block application state machine.
62 Number of EEPROM blocks that have been modified since last burn. This value will
count down to zero when the configuration is saved.
61 Controls saving of configuration.
TM
fieldbus Protocol