Emerson Rosemount 3051 Manual page 97

Table C-1. Transducer Block Parameters (continued)
Parameter
PRIMARY_VALUE_RANGE
PRIMARY_VALUE_TYPE
SECONDARY_VALUE
SECONDARY_VALUE_UNIT
SENSOR_CAL_DATE
SENSOR_CAL_LOC
SENSOR_CAL_METHOD
SENSOR_CAL_TYPE
SENSOR_CAL_WHO
SENSOR_FILL_FLUID
SENSOR_ISOLATOR_MTL
Index
Number Description
15 The high and low range limit values, the engineering unit code, and the number of
digits to the right of the decimal point to be used to display the final value.
Valid engineering units are the following:
1130 = Pa
1133 = kPa
1137 = bar
1138 = mbar
1139 = torr
1140 = atm
1141 = psi
2
1144 = g/cm
2
1145 = kg/cm
1148 = inH O @ 68 °F
2
1151 = mmH O @ 68 °F
2
1154 = ftH O @ 68 °F
2
1156 = inHg @ 0 °C
1158 = mmHg @ 0 °C
13 Type of measurement represented by the primary value.
107 = Differential pressure
108 = Gage pressure
109 = Absolute pressure
29 The secondary value, related to the sensor.
30 Engineering units to be used with SECONDARY_VALUE.
1001 °C
1002 °F
25 The last date on which the calibration was performed.This is intended to reflect the
calibration of that part of the sensor that is usually wetted by the process.
24 The last location of the sensor calibration. This describes the physical location at
which the calibration was performed.
23 The last method used to calibrate the device.
103 = factory trim standard
104 = user trim standard
35 The type of last sensor calibration.
0 = Differential pressure
1 = Gage pressures
2 = Absolute pressure
252 = Unknown
26 The name of the person responsible for the last sensor calibration.
28 Type of fill fluid used in sensor.
0 = Undefined
1 = Silicone
2 = Inert
3 = Undefined
7 - Neobee
251 = "None"
252 = "Unknown"
253 = "Special"
27 Defines the construction material for the isolating diaphragms.
2 = 316 Stainless Steel
3 = Hastelloy C
4 = Monel
5 = Tantalum
253 = "Special"
™
Block Information
C-3