Table of Contents
Advertisement
Installer Manual Siata V132-SFE-EV-VIRIDION - Maintenance
9.2.4. Motor replacement
No.
A
Using a screwdriver, unscrew (1).
B
Remove the back panel (2).
C
Using a screwdriver, unscrew (3).
D
Remove the cover (4) by pushing its sides as shown.
E
Disconnect the conductivity probe (10).
F
Pull the electronic board (9).
G
Disconnect the flat cable (8) and guard the electronic board (9).
H
Using a screwdriver, unscrew the two screws (11).
I
Remove the motor (6).
J
Remove the pinion (7) and check the condition of the spring (5).
K
If necessary, unscrew and change the spring (5) using pliers.
L
Replace the motor (6).
M
Reverse above procedure steps to rebuild.
9.2.5. Micro-switch replacement
No.
A
Using a screwdriver, unscrew (1).
B
Remove the back panel (2).
C
Using a screwdriver, unscrew (3).
D
Remove the cover (4) by pushing its sides as shown.
E
Disconnect the conductivity probe (10).
F
Pull the electronic board (9).
G
Disconnect the flat cable (8) and guard the electronic board (9).
H
Disconnect the micro-switches (12).
Note
Pay attention to the connector order.
I
Remove the micro-switches (12) by pulling the clips (13) as shown.
J
Replace the micro-switches (12).
K
Reverse above procedure steps to rebuild.
78 / 110
Operation
Operation
Ref. MKT-IM-009 / C - 08.06.2018
Advertisement
Table of Contents
