Table of Contents
Advertisement
Installer Manual Siata V132-SFE-EV-VIRIDION - Programming
Variable brining function
Note
If the variable brining function is enable, the brine tank will be filled for brine preparation
before regeneration.
Note
After each 10 regeneration cycles, the controller will perform the next regeneration with no
optimization of the salt usage. This to preserve resin bed efficiency.
A
Use
and
to enable or disable the brining function.
B
Press
to validate and switch to the next parameter.
Refill option
Note
This option is displayed only if Vb (brining function) is set to OFF.
Note
This option defines if the brine tank refill cycle is done before (0) or after (1) each
regeneration.
A
Use
and
to set the brine tank refill.
B
Press
to validate and switch to the next parameter.
Inlet water hardness
Note
This option is displayed only if SH (regeneration mode) is set to 1 or to 2.
Set the inlet water hardness in °f (French degrees), °d (German degrees)
or mg/L of CaCO
.
3
A
Use
and
to set the hardness.
B
Press
to validate and switch to the next parameter.
52 / 110
Ref. MKT-IM-009 / C - 08.06.2018
Advertisement
Table of Contents
