Table of Contents
Advertisement
Installer Manual Siata V132-SFE-EV-VIRIDION - Troubleshooting
10.1. Alarm messages
Inhibit signal
There is an inhibit signal input. The following screen alternates with the
service screen in the display. Any incoming regeneration is blocked.
Salt alarm
No more salt in the brine tank. Fill the brine tank with salt if a sensor is
present. Filling the tank instantly activates the salt sensor and turns off
the salt alarm icon. If there is no salt sensor, fill the brine tank with salt
and press any of the controller buttons. During the salt alarm,
regenerations are not carried out.
Technical service request
Active at regular intervals (in weeks) that may be set by after-sales
service. The alarm is deactivated by pressing any of the controller
buttons.
FR01
End of cycle alarm. The module cannot find the end of cycle. During the
end of cycle alarm, regenerations are not carried out.
AL02
Conductivity reading error. The controller couldn't register conductivity
values during all or part of the regeneration cycle.
AL04
Conductivity too high. The value of the conductivity at the end of the
regeneration is too high.
98 / 110
Ref. MKT-IM-009 / C - 08.06.2018
Advertisement
Table of Contents
