Table of Contents
Advertisement
6.4.2. Intermediate programming
Entering the intermediate menu
A
Press
and
B
Enter the password.
→ See "Access password", page 49.
Regeneration mode
SH0: Time clock regeneration on predefined days;
SH1: Volumetric delayed regeneration;
SH2: Volumetric immediate regeneration;
SH3: Regenerations are initiated based upon a programmed time interval (every 2, 3, 4, 6, 8 or 12
hours). The first generation starts at the regeneration time set in the basic menu and following
regeneration will be carried out depending on the programmed interval;
SH4: Time clock regeneration.
Set the regeneration mode.
A
Use
and
to change the selection.
B
Press
to validate and switch to the next parameter.
Display units type
Note
The display shows the unit use for remaining volume.
Note
The volume unit can be set in liters (Lt), in cubic meters (MC) or in gallons (GL).
Note
This parameter can be modified only in the advance programming menu.
Unit used for remaining volume:
A
Press
to switch to the next parameter.
Interval between regenerations
Note
This option is displayed only if SH (regeneration mode) is set to 3.
Set the interval between regenerations: 2, 3, 4, 6, 8 or 12 hours:
A
Use
and
to set the interval.
B
Press
to switch to the next parameter.
Ref. MKT-IM-009 / C - 08.06.2018
Installer Manual Siata V132-SFE-EV-VIRIDION - Programming
for 5 seconds to access the intermediate menu.
51 / 110
Advertisement
Table of Contents
