Ignition system, servicing
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Next&type=repair&id=...
- Read readiness code
memory has been erased or Engine Control
Module (ECM) was disconnected from battery
positive, readiness code must be generated
again
Page 01-149
Checking sequence for Camshaft Position
(CMP) Sensor 2 -G163-
- Disconnect 3-pin connector -2- from Camshaft
Position (CMP) Sensor 2 -G163-.
Note:
Mark connector and component before pulling
connector off.
- Connect multimeter to measure voltage at
terminals 1 (positive) and 3 (Ground) of
Camshaft Position (CMP) Sensor connector
using adapter cables from V.A.G 1594.
- Switch on ignition.
Specification: at least 4.5 V
- Switch off ignition.
Página 27 de 51
28-20
Page 01-146
. If DTC
.
12/2/2005