Siemens SIMATIC ET 200iS Manual page 166

Maintenance
Table 8-2
Module
Power supply
module PS
Interface module IM
151-2
Electronics module
Removing and Inserting Electronics Modules
Remove and insert the electronics modules as described in the section Wiring.
Note
Check the two coding elements before inserting the new electronics module in the
terminal module.
8-4
Requirements
Remove
and Insert
yes Remove: Failure of the ET 200iS (the same status
as if the power supply is turned off).
Insert: Startup of the ET 200iS
yes Remove: Failure of the ET 200iS
Insert: The ET 200iS parameters must be assigned
from a PG.
yes Remove: Failure of the sensor/actuator
Insert: Sensor/actuator operational
Effects on the ET 200iS
ET 200iS Distributed I/O Station
A5E00087831-02