Adjusting The Anti-Scalp Rollers - Toro Z Master Professional 6000 Series Operator's Manual

Adjusting the Height-of-Cut Pin
Adjust the height-of-cut from 25 to 140 mm (1 to
5-1/2 inches) in 6 mm (1/4 inch) increments by moving
the clevis pin into different hole locations.
1. Move the transport lock to the L
2. Push on the deck-lift pedal with your foot and
raise the mower deck to the Transport position
(also the 140 mm or 5-1/2 inch cutting-height
position) as shown in
3. To adjust, rotate the pin 90 degrees and remove
the pin from the height-of-cut bracket
25).
4. Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired, and
insert the pin (Figure
5. Push on the deck lift, pull back on the transport
lock, and slowly lower the mower deck.
Figure 25
1. Deck-lift pedal
2. Height-of-cut pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, adjust the
height of the anti-scalp rollers.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position and set the parking brake.
position.
OCK
Figure 25.
(Figure
25).
3. Transport lock
-
EUTRAL LOCK
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the rollers to match the height of cut.
1. Anti-scalp roller
2. Spacer
3. Bushing
1. Anti-scalp roller
2. Bushing
g027343
27
Figure 26
4. Flange nut
5. Bolt
Figure 27
3. Flange nut
4. Bolt
g001102
g001101