Table of Contents
Advertisement
Adjusting the Height-of-Cut Pin
The height-of-cut is adjusted from 25 to 140 mm (1
to 5-1/2 inches) in 6 mm (1/4 inch) increments by
relocating the clevis pin into different hole locations.
1.
Move the transport lock to the lock position.
2.
Push on the deck-lift pedal with your foot, and
raise the mower deck to the transport position
(also the 140 mm (5-1/2 inches) cutting height
position) as shown in
3.
To adjust, rotate the pin 90 degrees and remove
the pin from the height-of-cut bracket
28).
4.
Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired, and
insert the pin
(Figure
5.
Push on the deck lift, pull back on the transport
lock, and slowly lower the mower deck.
Figure 28
1. Deck-lift pedal
2. Cut-of-height pin
Figure
28.
(Figure
28).
3. Transport lock
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1.
Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Adjust the anti-scalp rollers as shown in
29
and
Figure
1. Flange nut
2. Anti-scalp roller
g027343
27
EUTRAL
30.
Figure 29
3. Bushing
4. Bolt
-
LOCK
Figure
g024242
Advertisement
Table of Contents
