Arrow DECA User Manual page 96

 Connect the DECA board to the LCD monitor with the on-board HDMI connector via an HDMI
cable.
 Power on the DECA board.
 Use File Manager to locate the "HDMI_TX_NIOS\demo_batch" folder. Launch the configuration
and program download process by double clicking "test.bat" batch file. This will configure the
FPGA, and download the demo application to the board and start its execution. A console
terminal will be kept on the screen and the user can interact with the demo application through
the console box. After it's done the screen should look like the one shown in
command line interface is provided to interact with the on-board HDMI transmitter. Note that
the commands are all case-sensitive.
Figure 7-3 Launch the HDMI TX Demonstration using the "demo_batch" Folder
DECA User Manual
95
Figure 7-3. A tiny
www.terasic.com
May 22, 2015