Arrow DECA User Manual page 90


Quartus II 15.0

Nios II Eclipse 15.0
 Demonstration Source Code

Quartus Project directory: DECA_DDR3_Nios_Test

Nios II Eclipse: DECA_DDR3_Nios_Test\Software
 Nios II Project Compilation
Before you attempt to compile the reference design under Nios II Eclipse, make sure the project is
cleaned first by clicking 'Clean' from the 'Project' menu of Nios II Eclipse.
 Demonstration Batch File
Demo Batch File Folder:
DECA_DDR3_Nios_Test\demo_batch
The demo batch file includes following files:

Batch File for USB-Blaster II : test.bat, test.sh

FPGA Configure File : DECA.sof

Nios II Program: DECA_DEMO.elf
 Demonstration Setup

Make sure Quartus II and Nios II are installed on your PC.

Power on the DECA board.

Use USB cable to connect PC and the DECA board (J10) and install USB Blaster driver if
necessary.

Execute the demo batch file "test.bat" for USB-Blaster II under the batch file folder,
DECA_DDR3_Nios_Test\demo_batch

After Nios II program is downloaded and executed successfully, a prompt message will be
displayed in nios2-terminal.

The program will display progressing and result information, as shown in
DECA User Manual
89
Figure 5-17.
www.terasic.com
May 22, 2015