Arrow DECA User Manual page 78

 Demonstration Source Code

Project directory: DECA_TEMP

Bit stream used: DECA _TEMP.sof

Nios II Workspace: DECA _TEMP\Software
 Demonstration Batch File
Demo Batch File Folder: DECA _TEMP\demo_batch
The demo batch file includes the following files:

Batch File: DECA_TEMP.bat, DECA _TEMP.sh

FPGA Configure File : DECA _TEMP.sof

Nios II Program: DECA _TEMP.elf
 Demonstration Setup, File Locations, and Instructions

Make sure Quartus II v15.0 and Nios II v15.0 are installed on your PC.

Power on the DECA board.

Connect USB Blaster II to the DECA board and install USB Blaster II driver if necessary.
DECA User Manual
Figure 6-5 Block diagram of the Temperature Demonstration
77
www.terasic.com
May 22, 2015