Arrow DECA User Manual page 72

 Demo batch file folder: HDMI_TX\demo_batch
 Batch file: test.bat
 FPGA Configure File:HDMI_TX.sof
 Demonstration Setup
 Make sure Quartus II and USB-Blaster II driver are installed on your PC.
 Connect the DECA board to the LCD monitor with the on-board HDMI connector via an HDMI
cable.
 Power on the DECA board .
 Use File Manager to locate the "HDMI_TX\demo_batch" folder. Launch the configuration and
program download process by double clicking "test.bat" batch file. This will configure the
FPGA, download the demo application to the board and start its execution. After it's done the
screen should look like the one shown in

Figure 5-17 Launching the HDMI TX Demonstration using the "demo_batch" Folder
Wait for a few seconds for the LCD monitor to power up itself. And you should see a pre-defined
video pattern shown on the monitor, as shown in
HDMI display speaker when your press KEY0 on the DECA board.
DECA User Manual
Figure 5-17.
Figure 5-18. you can hear beep sound from the
71
www.terasic.com
May 22, 2015