Introduction; General Safety Information - zortrax Inkspire User Manual

Introduction

Read this User Guide carefully and thoroughly before operating the Zortrax Inkspire for the first
time. The User Guide includes basic information about the 3D printer, safety and protection
guidelines as well as advice on preparing the machine for the first printing process and
basic maintenance work. Ignorance and non-compliance with these instructions may result
in property damage, injuries, device failures or lower quality of 3D prints. It is also necessary
to ensure that every 3D printer user knows, fully understands and follows the instructions
provided in this User Guide.
The Manufacturer makes every effort to ensure that Zortrax products are safe in transportation,
installation, usage, storage and disposal. However, due to the lack of direct and ad hoc control
as well as other conditions influencing the device and those that are beyond the Manufacturer' s
knowledge, the Manufacturer is not responsible for damage, injuries, failures and costs
resulting from improper transportation, installation, usage, storage and disposal.
Furthermore, the users should take into consideration the risk of possible damage of the
device resulting from defects in material and workmanship.
The users are responsible for qualifying and determining the intended use of 3D printed
models. The Manufacturer takes no responsibility for any use of printed objects, especially
when those objects constitute a part of safety devices or strictly regulated by specific rules
medical, military or space science equipment.
Due to the size and specificity, the Zortrax Inkspire is not intended for use by minors and by
people with reduced manual, motor and psychomotor skills. The Manufacturer recommends
providing assistance and guidance to people with disabilities and older adults who wish to
operate the printer.

General Safety Information

This User Guide contains important safety directions that should be followed during installation
and operation of the Zortrax Inkspire. It also mentions situations which require special attention
and includes warnings against negligence and misuse that could cause damage or injuries.
Always read the safety data sheets available at: https://zortrax.com/resins/. They are a source
of basic information and safety procedures for the materials you bought. It is essential to
regularly update the firmware to avoid any kind of failures.
©2019, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
3
document are registered trademarks of Zortrax and are subject to legal protection.