zortrax Inkspire User Manual page 43

12. Insert the resin filter into the silicone funnel and put them together in the bottle with resin. Pour the
resin left in the tank through the filter and funnel. If it's necessary, use a plastic spatula.
NOTE! It is advisable to filter the already used resin after each print. Mix it with the fresh resin to make sure
that there are no cured remains in the liquid, as they could have a negative influence on the quality of the
next print. Mixing used and fresh resin also helps to extend the resin lifespan.
13. Clean the resin tank with a paper towel. You can also use 99% isopropyl alcohol for that purpose.
©2019, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
43
document are registered trademarks of Zortrax and are subject to legal protection.