Table of Contents
Advertisement
5 Getting Started
5.2 Assembly
5.2.3
Assembly
Devices with Display for Panel Flush Mounting
To install the device into a switch panel, proceed as follows:
✧
Push the device in installation position into the cut-out of the switch panel and hold the device tight.
✧
Attach one of the supplied mounting elements each on both sides of the housing.
Mounting plate
1 mm (0.04 inch), steel
Figure 5-2
✧
Swing the mounting element (provided with the device) over the rear cone.
✧
Move the mounting element to the position. Use a screw driver (0.6 mm x 4.5 mm) to fix the mounting
elements until the slipping clutch takes effect.
NOTE
The above mounting instructions must be performed correctly to provide sufficient protection against touching
live parts.
UL-Certification Conditions
Field Wires of Control Circuits shall be separated from other circuits with respect to the end-use requirements!
74
Mounting element
Stepwise Installation of the SICAM P850/P855 into a Switch Panel (devices with display)
SICAM P850/P855, 7KG85xx, Device Manual
E50417-H1040-C482-A6, Edition 10.2018
Advertisement
Table of Contents
