Table of Contents
Advertisement
7.3
Configuration of the Device
NOTE
The device contains two sets of parameters. The set of parameters currently used for device operations is the
active set of parameters. The inactive set of parameters is called the passive set of parameters.
The following sections describe how to change and enable the passive set of parameters.
7.3.1
Device Configuration Procedure
If you have not changed the set of parameters since the first start of the device (see Initial Start of the
Operation), use the factory settings (see Setting the Operational Parameters to Setting Administrative
Parameters). To change the settings of the set of parameters, proceed as follows:
✧
Click the Configure tab on the user interface.
Figure 7-15
✧
Select the Prepare menu in the navigation window and then either Get device configuration or Open
configuration from file.
SICAM P850/P855, 7KG85xx, Device Manual
E50417-H1040-C482-A6, Edition 10.2018
Configure Tab
7 Operation at Use of a PC
7.3 Configuration of the Device
113
Advertisement
Table of Contents
